Gas cap 30-31 Who sells a cap that is vented ? My car has stalled twice since gassing up . It is the cap because it runs fine with loose cap and I can hear wooosh when I release the bad cap
|
Re: Gas cap 30-31 Snyders, their cap has 2 rivets instead of one. keeps the gasket in place and not covering the vent hole.
|
Re: Gas cap 30-31 1 Attachment(s)
This one
|
Re: Gas cap 30-31 Make sure it is not a radiator cap with is not vented. I have the Snyders cap and I like it.
|
Re: Gas cap 30-31 |
Re: Gas cap 30-31 To be honest, I would prefer a non vented cap and a pipe leading from the top of the tank to somewhere under the car or to the inlet to the carburetor or some other location. With the windshield open I get the gas fumes from the vented cap coming into the inside of the car. On my Model T I had a small diameter copper pipe leading from the top of the gas tank to the exhaust pipe before the muffler. It added a little pressure to the tank so that I could go up steep hills. Plus, the exhaust gas, being free of most oxygen, was safer than having air in the gas tank. There was a coil of the small diameter copper tubing so that any exhaust gas was cooled before it got into the gas tank. The gas cap was sealed and had an O ring gasket.
|
Re: Gas cap 30-31 Why not clean your existing cap?
|
Re: Gas cap 30-31 I not only cleaned the vent holes in my gas cap but added an additional one. Be careful not to drill into the bottom of the pretty chrome part. Chap
|
Re: Gas cap 30-31 I tried drilling but it still did not vent properly
I ordered from Snyder this a.m. |
Re: Gas cap 30-31 Quote:
2 1/4" and the gas cap is 2 5/8". |
All times are GMT -5. The time now is 01:12 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.