1948 H 226 engine head bolt torque and V8's Quick question (ok two) what is the torque for the head bolts and does anyone have a chart to show proper order to tighten the bolts?
Thanks |
Re: 1948 H 226 engine head bolt torque 1 Attachment(s)
Says 65-70lbs in the manual.
|
Re: 1948 H 226 engine head bolt torque Thank you very much. Just what I needed. :)
|
Re: 1948 H 226 engine head bolt torque Is that no. good for all flatheads V-8's too? Al
|
Re: 1948 H 226 engine head bolt torque and V8's Added V8 to title. I'll bump it and see if we can find out.
|
Re: 1948 H 226 engine head bolt torque and V8's A little high for what a lot of people like for the v8. The thickness of the head surface on the v8 is fairly thin. Also that high a torque is not required to get a good head gasket seal. Around 55 works fine in most cases.
|
Re: 1948 H 226 engine head bolt torque and V8's Thanks for the reply JS, now that I've tightened mine to 60 ft. lbs. Al
|
Re: 1948 H 226 engine head bolt torque and V8's Torque to 65-70 like the manual states. Also the manual states- 65-70 for the 8BA. Cylinder head nuts for both the 6 and the 8 is 50-55.
|
All times are GMT -5. The time now is 06:55 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.