Police head What is the correct head gasket to use on a model a police head?
|
Re: Police head |
Re: Police head The original Ford gasket was A-6050-B, it looked similar to the Model B head
gasket but without the steam holes. Not sure what is available now. |
Re: Police head I always used the one intended for a Model B Ford.
Charlie Stephens |
Re: Police head Thanks I will use the new B gasket without the steam holes
|
Re: Police head The Model B Ford has a stock compression ratio of 4.6:1 which is just a tad more than the stock Model A compression ratio of 4.2:1. So the Model B gasket has no strength advantage. The Model A Police Head has a compression ratio of 5.5:1, so use the head gasket suppliers sell for high compression heads.
|
Re: Police head Quote:
Charlie Stephens |
Re: Police head No intention to high jack this thread, should you be on a tour and have a high compression head gasket as a spare and someone with a standard head blew a head gasket could you install that gasket with a standard head and have no fear? and if not to confusing could a normal gasket be loaned to the high compression head owner just to get by?.
|
Re: Police head Quote:
There aren’t really high compression gaskets per se. There are A head gaskets and B head gaskets. |
All times are GMT -5. The time now is 01:06 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.