56 dash question, extra hole? Got the dash out and cleaning it up for primer. I now have a extra hole in the dash where the ignition originally went. I am going with a steering column that has the ignition on the column so have no need for the dash ignition. Question is what do you do with the old ignition hole? I could add another lighter power port but two would look dorky. I could cut it out and fill it in but that is a fair size chunk to cut out. Anyway any ideas? Thanks
|
Re: 56 dash question, extra hole? When I bought my 58 Chevy wagon, it had dealer installed a/c in it, with an air vent at each end of the dash, down low. Most of the a/c was missing, so I sold what was left. I welded up the holes, working upside down (the dash doesn't come out). That was fun, but you can't tell it. The holes were very large.
|
Re: 56 dash question, extra hole? 1 Attachment(s)
Maybe a cover as shown below? Paint To Match?
They were commonly used back when. |
Re: 56 dash question, extra hole? I used plugs like Kultulz shows above. NAPA had flat black or chrome to chose from.
|
Re: 56 dash question, extra hole? Put the original switch and trim ring there for looks, just not connected to anything. It could confuse somebody trying to steal the car.
|
Re: 56 dash question, extra hole? Would be a good location for an inside hood release or hand throttle.
|
Re: 56 dash question, extra hole? Quote:
|
Re: 56 dash question, extra hole? Add a choke cable there.
|
Re: 56 dash question, extra hole? Use the key on the column for ignition and install a push button in the dash to engage the starter.
|
Re: 56 dash question, extra hole? get a knob that matches the rest in the dash and epoxy it to whatever you put in the hole and it will blend in with the rest.
|
Re: 56 dash question, extra hole? Thanks for the ideas guys.
|
All times are GMT -5. The time now is 12:41 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.