Holley 94 vacuum port plug I am looking for a source for the vacuum port plug that fits the Holley 94 carb. It appears to be an odd size / thread type. Any one have any info that might help me locate them?
|
Re: Holley 94 vacuum port plug SAE 45degree flare plug fits there...Eaton has them or any major supplier of brass fittings.
Thread is UNF if i got it right so not exotic... |
Re: Holley 94 vacuum port plug The threads are 3/8"-24.
Sal |
Re: Holley 94 vacuum port plug Thanks for the info guys
|
Re: Holley 94 vacuum port plug When I had to plug them, I always used a "Ford Nut" soldered up. Are you telling me a 3/8-24 set screw would have saved those rare pieces?
|
Re: Holley 94 vacuum port plug I've cut off the end of a 3/8"-24 bolt before and then cut a screw drive slot/filed it flat, instead of using a brass original soldered shut.
Sal |
Re: Holley 94 vacuum port plug Sal, does it need to be a ferrule type thread?
|
Re: Holley 94 vacuum port plug Answer to my last question was no based on small amount of vacuum being plugged.
|
All times are GMT -5. The time now is 03:58 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.