1936 ford roadster dimension needed please! Hey guys i'm so close to wrapping up this 36 restoration, trying to fit the top irons now. I need the dimension from center of windshield post stud to center of windshield post stud, basically where the top sits over. Can anyone give me that measurement so i can see if this one is in the ballpark. Im getting about 46-3/8" but the wood header fits pretty tight, hard to get back on once you take it off. Need to figure out whats going on
almost there https://scontent-ams3-1.cdninstagram...MDI1MA%3D%3D.2 |
Re: 1936 ford roadster dimension needed please! I don't have your measurement, but boy........do I LIKE that! DD
|
Re: 1936 ford roadster dimension needed please! that is a really nice example of a 36 roadster, love the colour. I could get the information for you tomorrow if no on else chimes in before then.
it was bothering me so I went out to the garage and measured mine - its bang on 46 3/8 between the centres of the studs. |
Re: 1936 ford roadster dimension needed please! Quote:
|
Re: 1936 ford roadster dimension needed please! Quote:
|
Re: 1936 ford roadster dimension needed please! 3 Attachment(s)
Hi Everyone, rickyracer1962, These are from my '36 Phaeton. Dad and I re-did the top about six years ago. Used the aftermarket header, and needed to work the wood and some of the aftermarket top irons that fit over the windshield posts. Measurement is outside-to-outside, so your 46 3/8 seems right. It's not the windshield's fault.
|
Re: 1936 ford roadster dimension needed please! Ford Barner 40 Grit has one, Maybe you can contact him and get the measurement . Just a thought.
|
Re: 1936 ford roadster dimension needed please! |
Re: 1936 ford roadster dimension needed please! thanks for all the info & pictures guys. Ill have to figure out how to make this work. This car is going to fight till the very end of the build hahaha
|
All times are GMT -5. The time now is 12:12 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.