Rods Okay I am getting read to do the engine rebuild on the 30 took it apart it looks great other than the babit in the oil pan. Can I have the rods machined to accept new bearings? I have seen the ones that wrap around to the side like the babit does. I'm going to have the block machined and line bore for main bearings.
|
Re: Rods I’m going to have new babbit poured and line bored for mains and send my rods out for exchange with rods with new babbit (after my crank is turned).
|
Re: Rods okay I'm wanting information. this is probably to the best place to get it. i will start making some phone calls and visiting machine shop with rods.
|
Re: Rods Quote:
|
Re: Rods thanks. I was just wanting to use the original rods since the care is original except paint. I will save them just to have. again thank you
|
Re: Rods Berts sells rods for about $60 apiece.
Good Luck |
All times are GMT -5. The time now is 01:07 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.