Generator Armature - Long Taper Does anyone know if there are NEW generator armatures available with the long (7/8") taper? For some reason, the big parts suppliers only sell the short (1/2") taper, which was only used after March (May?) 1930 per the Judging Standards. I'd like to make mine correct for my June '29.
|
Re: Generator Armature - Long Taper A; maybe someone has a good armature, put an ad in the classifieds
B; get yours re wound C; to be fully correct you also need the correct cover band. ( I know there are differences for the years/months but can not tell you what they are) |
Re: Generator Armature - Long Taper |
Re: Generator Armature - Long Taper Thank you for the replies. Looks like, as I suspected, new long-taper armatures are not available.
|
Re: Generator Armature - Long Taper Would it be possible to take a short taper and recut it to a long taper?
|
Re: Generator Armature - Long Taper Quote:
There were a few generators with the long taper and rear bushing during the change over period of March 1930. I'll see if I can find my picture of the 3 different armatures. |
Re: Generator Armature - Long Taper I should point out that PV Antique & Classic Ford, which I found through another Fordbarn post, is just now having new long-taper generator armatures manufactured. They will not be available soon enough for my project, so I'm going with a rewound original armature.
|
Re: Generator Armature - Long Taper 1 Attachment(s)
Here's that picture of the 3 different armatures for the long generator.
Notice the top short taper uses a larger thread on the pulley bolt. |
All times are GMT -5. The time now is 07:53 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.