!941 Ford Coupe vent Window Is it possible to have a glass cut to fill the opening of the vent window and window there by eliminating the vent window?? Sorry that is for the front and passenger door ??THANKS Jerry
|
Re: !941 Ford Coupe vent Window I'm not sure about '41, but in'46 some models had a rear vent window that did not open. I don't know if the rubber seal is still available for these models. Check with some of the suppliers.
|
Re: !941 Ford Coupe vent Window Quote:
https://farm5.staticflickr.com/4355/...eb455410_z.jpgUntitled by philip sauber, on Flickr |
Re: !941 Ford Coupe vent Window So if I understand you put a permanent glass in the vent that use to pivot. I was thinking of a glass that would roll up and down and cover the window and vent window area? Thanks Jerry
|
Re: !941 Ford Coupe vent Window So your wanting to make it like say a 38/39 door window?
|
Re: !941 Ford Coupe vent Window Yes exactly but I am sure that window want fit a 1941???I guess. Thanks Jerry
|
Re: !941 Ford Coupe vent Window If I'm reading your question correctly you want to remove the vent window and have a one piece glass. A lot of hot rodders do this, so I would ask the question on the HAMB. A couple of companies that come to mind are Specialty Power Window and Electric-Life. I don't know if your stock crank style equipment will be able to handle a larger window and you will have to fabricate a track for the front of the door.
|
Re: !941 Ford Coupe vent Window OK thanks for the info and I will contact them. Jerry
|
Re: !941 Ford Coupe vent Window Does any one know the dimensions of the 1938 Ford coupe front door window glass< ?Thanks Jerry
|
All times are GMT -5. The time now is 08:52 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.