installing windshield rubber gasket. Is the groove in the windshield frame supposed to be tight enough to retain the rubber gasket without the use of adhesive? this is especially noticeable along the lower portion of the frame?
|
Re: installing windshield rubber gasket. Yes,push it in with a thin putty knife.Groove must be clean.
|
Re: installing windshield rubber gasket. My F1 windshield was put in without adhesive. It stays in just fine, but when I drive in the rain there’s always a couple of streams of water running down the top of the dash panel.
. |
Re: installing windshield rubber gasket. He should have stated that he has a '33 Ford.Its different than an F1.
|
All times are GMT -5. The time now is 08:51 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.