PM7 & Model 59 Ford carb setup City:
Mandan
State:
ND
Price:
940
New Thickstun reproduction PM7 and matching Model 59 Ford carburetors. Carbs have been rechromated, and rebuilt with #49 jets, 4.5 power valves, and leather accelerator pumps. Steel pieces were rechromated. Choke lever and kickers were replaced with handmade/polished stainless pieces. The fuel lines, fuel block, choke cable bracket, and fuel pump block-off are made from aluminum and polished. The fuel block bracket is stainless, and the inter-carb linkage is polished aluminum, stainless, and copper. The oil fill cover is a Tecumseh aluminum piston, polished and fitted to an o-ring equipped stem with brass detents to keep it in place. I had fun building it, and am looking for a new home for the setup. $940 shipped in the US.
http://i131.photobucket.com/albums/p...ps05a7a053.jpg http://i131.photobucket.com/albums/p...ps2018feb6.jpg http://i131.photobucket.com/albums/p...psb0b6d571.jpg http://i131.photobucket.com/albums/p...psfdc9d20d.jpg |
Re: PM7 & Model 59 Ford carb setup Ttt
|
Re: PM7 & Model 59 Ford carb setup are you making the heads too?
|
Re: PM7 & Model 59 Ford carb setup No, didn't "make" the manifold, either.
|
Re: PM7 & Model 59 Ford carb setup Would you sell the intake separately? If not could you tell me the source for these.
|
All times are GMT -5. The time now is 11:14 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.