Square nuts for the tail lamp Does anyone have a photo of the original square nuts that hold the tail lamp stand (bracket)to the rear fender? From what I have found they are supposed to be carriage bolt nuts. What would be different from regular square nuts? Check part number A 21664 carriage nut in Mick Isbel's book. Thanks , Norm
|
Re: Square nuts for the tail lamp The Ford parts book shows 34095-S2 1/4"-20 (3/16"x1/2") square nut if I'm
reading it right. Bob |
Re: Square nuts for the tail lamp Quote:
|
Re: Square nuts for the tail lamp 1 Attachment(s)
Something like this I'm hoping is correct, as this is what I am restoring for my show car.
Ray |
Re: Square nuts for the tail lamp 1 Attachment(s)
Here is a photo of the ones on Dave Lopes' very low mileage original 1929.
|
Re: Square nuts for the tail lamp Thanks everyone for the information. I had the type shown in the photos but the wrong finish. I was marked down for reproduction nuts. I was wondering if the flat nuts were correct but your help will keep me on track. Thanks again , Norm
|
All times are GMT -5. The time now is 11:59 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.