"8BA" Crank Pulley Car/Truck Inquiry I had this post earlier:
https://www.fordbarn.com/forum/showt...91#post1899791 I have since discovered that the incorrect crank pulley nut was used (basically it would almost pass thru the bore of the pulley !) Currently I don't have a spare truck pulley but I do have a 52 Merc Car pulley, It appears the bolt & washer from the merc engine are what I need on the motor (they are all the same for that era it appears, obviously the Merc pulley is a narrow belt pulley, is the spacing the same from a 52 truck motor to a 52 car motor for example ? I assume the merc pulley will fit on my motor, wondering if I could just run narrow belts, but not sure if the car crank pulley belt grooves align to the truck water pumps, fan & genny, I don't think the wide truck pulleys will care if a narrow belt is running in them, but the offset is a whole other issue... The 52 pulley is an hour away from me right now so I thought I would do some pre investigation. |
Re: "8BA" Crank Pulley Car/Truck Inquiry A v-belt grips by the sides of the belt. A narrow belt running in a wide pulley may be ok to “get you home” but I don’t think it’s gonna work for a long period. Should be plenty of those pulleys around.......Mark
|
Re: "8BA" Crank Pulley Car/Truck Inquiry Dennis if you can not find one locally I will pull one and send it to you! I am Roadster1927 on the hamb. Gary
|
Re: "8BA" Crank Pulley Car/Truck Inquiry Quote:
|
Re: "8BA" Crank Pulley Car/Truck Inquiry All pulleys need to be the same size to match.
|
Re: "8BA" Crank Pulley Car/Truck Inquiry 1 Attachment(s)
Sourced the correct pulley including proper 7/8" bolt with washer from a "bush find" truck motor - All back together & working properly.
|
All times are GMT -5. The time now is 11:07 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.