52 F1 cluster gear 1 Attachment(s)
I have been working on building a 52 F1 3 speed remote shift transmission. Mostly all NOS parts including the case. I have built several before, but this time I am paying more attention to part fitment. I am using a NOS 27-23-17-13 cluster with needle bearings. I noticed the spacer isn’t a precise fit in the cluster bore. It’s not extremely loose, but not a tight fit either. I wonder why the spacer was designed that way? Seems like it’s an opportunity for transmission noise when the cluster rotates?
JB |
Re: 52 F1 cluster gear diameter? probably some inexpensive off the shelf tubing, noise it should be drowned in trans fluid and thus no noise
|
Re: 52 F1 cluster gear It is located by the shaft. Doesn’t matter how much it floats in cluster before shaft is installed.
|
All times are GMT -5. The time now is 03:56 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.