https://www.fordbarn.com/forum/ Looking for that hard to find Early V8 part? Post it here! en Thu, 04 Jun 2026 08:22:33 GMT vBulletin 60 https://fordbarn.com/forum/hamb/misc/rss.jpg https://www.fordbarn.com/forum/ https://www.fordbarn.com/forum/showthread.php?t=357982&goto=newpost Thu, 04 Jun 2026 07:42:29 GMT Seeking the above bearings, in .030/.004 size. Even single bearings...need two to make up a set, but will buy a whole set if available. Thanks... Seeking the above bearings, in .030/.004 size. Even single bearings...need two to make up a set, but will buy a whole set if available. Thanks Fordbarn. ]]> Early V8 Brian https://www.fordbarn.com/forum/showthread.php?t=357982 https://www.fordbarn.com/forum/showthread.php?t=357974&goto=newpost Wed, 03 Jun 2026 21:40:06 GMT Looking for a 16 x 5 x 5.5 straight wheel in good condition. Looking for a 16 x 5 x 5.5 straight wheel in good condition. ]]> Early V8 34ratrodder https://www.fordbarn.com/forum/showthread.php?t=357974 https://www.fordbarn.com/forum/showthread.php?t=357972&goto=newpost Wed, 03 Jun 2026 19:39:11 GMT 32-6 Rear Axle Bearings, most common replacement is Tinken Part No. 22168 it replaces Ford 18-4221, I need a pair of the tapered bearing only, not... 32-6 Rear Axle Bearings, most common replacement is Tinken Part No. 22168 it replaces Ford 18-4221, I need a pair of the tapered bearing only, not the race. Thanks. ]]> Early V8 TFB https://www.fordbarn.com/forum/showthread.php?t=357972 https://www.fordbarn.com/forum/showthread.php?t=357968&goto=newpost Wed, 03 Jun 2026 17:11:35 GMT Wanted 1932 Ford floor board. Wanted 1932 Ford floor board. ]]> Early V8 LPTIMOS https://www.fordbarn.com/forum/showthread.php?t=357968 https://www.fordbarn.com/forum/showthread.php?t=357965&goto=newpost Wed, 03 Jun 2026 11:13:55 GMT Looking for transport for a seat & frame to Prescott Az area. 507 456 1841. ]]> Early V8 34ratrodder https://www.fordbarn.com/forum/showthread.php?t=357965 https://www.fordbarn.com/forum/showthread.php?t=357932&goto=newpost Mon, 01 Jun 2026 15:27:16 GMT Looking for an original pair of 1932 Ford Cabriolet door garnish moldings. Thanks Jeremy Looking for an original pair of 1932 Ford Cabriolet door garnish moldings.
Thanks

Jeremy ]]> Early V8 Jeremy https://www.fordbarn.com/forum/showthread.php?t=357932 https://www.fordbarn.com/forum/showthread.php?t=357928&goto=newpost Mon, 01 Jun 2026 13:33:48 GMT Looking for a good set of Rods for a 37 flatty PM me an email and I will email you!!! Thank you Rockfla Looking for a good set of Rods for a 37 flatty


PM me an email and I will email you!!!


Thank you
Rockfla ]]> Early V8 rockfla https://www.fordbarn.com/forum/showthread.php?t=357928 https://www.fordbarn.com/forum/showthread.php?t=357903&goto=newpost Sun, 31 May 2026 00:25:44 GMT Looking for a 1937 - 40 steering box bracket. Repop ok. Looking for a 1937 - 40 steering box bracket. Repop ok. ]]> Early V8 thegreek https://www.fordbarn.com/forum/showthread.php?t=357903 https://www.fordbarn.com/forum/showthread.php?t=357880&goto=newpost Fri, 29 May 2026 18:27:48 GMT Looking for a left reinforce brace for x-member 1932. I also need the rumble lid hinges cast with numbers B-47430 and B-47431 for std. coupe. Looking for a left reinforce brace for x-member 1932. I also need the rumble lid hinges cast with numbers B-47430 and B-47431 for std. coupe. ]]> Early V8 jdpaxton https://www.fordbarn.com/forum/showthread.php?t=357880 https://www.fordbarn.com/forum/showthread.php?t=357874&goto=newpost Fri, 29 May 2026 12:33:35 GMT Wanted used 1932 Ford radiator cap and bezel. Thanks, Larry Wanted used 1932 Ford radiator cap and bezel.
Thanks, Larry ]]> Early V8 LPTIMOS https://www.fordbarn.com/forum/showthread.php?t=357874 https://www.fordbarn.com/forum/showthread.php?t=357851&goto=newpost Wed, 27 May 2026 21:58:18 GMT Need the upper most portion of a Cabriolet Cowl to repair the "A" pillars and cross bar with roof receivers on my Cabriolet. Also, a Cabriolet Windshield frame if possible. Thank you. Please email me direct at Thirty2ragtop@aol.com ]]> Early V8 thirty2ragtop https://www.fordbarn.com/forum/showthread.php?t=357851 https://www.fordbarn.com/forum/showthread.php?t=357848&goto=newpost Wed, 27 May 2026 19:31:53 GMT 1932 Ford original K member. About as good as you can find. Rivets were taken out carefully without any damage. $900. Will ship for costs involved.... 1932 Ford original K member. About as good as you can find. Rivets were taken out carefully without any damage. $900. Will ship for costs involved. call 63zero 93six 0142 for photos. Thanks Roger ]]> Early V8 Bulligen https://www.fordbarn.com/forum/showthread.php?t=357848 https://www.fordbarn.com/forum/showthread.php?t=357824&goto=newpost Tue, 26 May 2026 19:31:50 GMT Looking for a nice 1933/34 roadster rear window. Any leads most appreciated. Looking for a nice 1933/34 roadster rear window. Any leads most appreciated. ]]> Early V8 31pickemup https://www.fordbarn.com/forum/showthread.php?t=357824 https://www.fordbarn.com/forum/showthread.php?t=357802&goto=newpost Mon, 25 May 2026 17:16:51 GMT Been a while, thought I'd try again. Wanted 2 left hand and 2 right hand NOS 32-34 Ford tie rod ends. (No Model A's) Also a nice pair of 32-34 stock spindles. No Rusty Junk. Respond to gm03319@windstream.net


Found spindles, still need tie rod ends. ]]> Early V8 Krylon32 https://www.fordbarn.com/forum/showthread.php?t=357802 https://www.fordbarn.com/forum/showthread.php?t=357798&goto=newpost Mon, 25 May 2026 16:07:29 GMT Looking for a 1949 Merc Accessory Steering Wheel. Cash or partial trade w/ cash for original restored Crestliner Steering Wheel. DM me what you... Looking for a 1949 Merc Accessory Steering Wheel. Cash or partial trade w/ cash for original restored Crestliner Steering Wheel. DM me what you have.

Thanks! ]]> Early V8 Drylaker https://www.fordbarn.com/forum/showthread.php?t=357798