|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-24-2024, 10:20 AM | #11 |
Senior Member
Join Date: May 2010
Location: Lynden, Wa
Posts: 3,560
|
Re: The absolute 'MINIMUM' cylinder wall thickness....
OK, I am not a machinist by any stretch of the imagination. But, even to me when dad said the Model A could be bored to .125 that was way to big for me. I 'think'-and this is my opinion-if you stick with the .060 that would keep the walls thick enough to not risk any cracks, hot spots etc.
Again just my opinion-I know you were looking for actual numbers. Mike
__________________
1930 TownSedan (Briggs) 1957 Country Sedan |
|
|
Sponsored Links (Register now to hide all advertisements) |
|