The Ford Barn

alan · 06-25-2013, 09:25 AM

kind of out of my normal, but having trouble with trunk lid on a fastback, could someone post a picture of the arm where it connects with hinge or direct me to someplace to get one

Dave72dt · 06-25-2013, 01:23 PM

Any particular year? I could get one for 71-73 but that might not be correct for yours.

alan · 06-25-2013, 02:50 PM

it is on a 65, I have a picture and believe the link arm is too short, could you tell me the length of you arm? hole to hole thanks

Dave72dt · 06-28-2013, 04:04 PM

Sponsored Links (Register now to hide all advertisements)

right angle to right angle is 31 1/2". short arm is on the outside in the middle notch and goes over on the top side of the hinge from the rear seat side, long arms go to the inside. rods cross in the middle and have a plastic zip tie in the center to hold them together.

06-25-2013, 09:25 AM	#1
alan Senior Member Join Date: Jul 2010 Location: UPSTATESC Posts: 669	mustang fastback trunk torsion arm kind of out of my normal, but having trouble with trunk lid on a fastback, could someone post a picture of the arm where it connects with hinge or direct me to someplace to get one

06-25-2013, 01:23 PM	#2
Dave72dt Senior Member Join Date: May 2010 Location: SW WI Posts: 359	Re: mustang fastback trunk torsion arm Any particular year? I could get one for 71-73 but that might not be correct for yours.

06-25-2013, 02:50 PM	#3
alan Senior Member Join Date: Jul 2010 Location: UPSTATESC Posts: 669	Re: mustang fastback trunk torsion arm it is on a 65, I have a picture and believe the link arm is too short, could you tell me the length of you arm? hole to hole thanks

06-28-2013, 04:04 PM	#4
Dave72dt Senior Member Join Date: May 2010 Location: SW WI Posts: 359	Re: mustang fastback trunk torsion arm Sponsored Links (Register now to hide all advertisements) right angle to right angle is 31 1/2". short arm is on the outside in the middle notch and goes over on the top side of the hinge from the rear seat side, long arms go to the inside. rods cross in the middle and have a plastic zip tie in the center to hold them together.