|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-04-2016, 02:41 PM | #1 |
Senior Member
Join Date: Jun 2014
Location: Rocklin, CA
Posts: 779
|
RIMAC "Nok-In-Out" 21
The RIMAC company made a tool for installing and removing the press in grease fittings for the Model A. It was #21 and called a "Nok-In-Out". Has anyone seen one or have one I could get a picture of?
|
11-24-2023, 06:40 PM | #2 |
Member
Join Date: Aug 2010
Location: Las Cruces New Mexico
Posts: 51
|
Re: RIMAC "Nok-In-Out" 21
I think I have one. It's the only one I've seen in person.
|
Sponsored Links (Register now to hide all advertisements) |
|
11-24-2023, 09:08 PM | #3 |
Member
Join Date: Feb 2023
Posts: 84
|
Re: RIMAC "Nok-In-Out" 21
I have seen this tool and didn't know what it was for.
|
11-25-2023, 08:19 AM | #4 |
Senior Member
Join Date: May 2010
Location: Long Island, NY
Posts: 3,486
|
Re: RIMAC "Nok-In-Out" 21
I am guessing that the RIMAC Tool tool is placed against a press-in grease fitting and then hit with a separate hammer. Doing so would avoid damaging a grease fitting from an errant-placed blow with the RIMAC Tool.
__________________
Bob Bidonde |
11-25-2023, 10:58 AM | #5 |
Senior Member
Join Date: Feb 2014
Location: Boston, MA
Posts: 213
|
Re: RIMAC "Nok-In-Out" 21
The tee handle end is likely the tool to insert them. I want one.....
|
11-25-2023, 06:19 PM | #6 |
Senior Member
Join Date: Sep 2022
Location: SoCal
Posts: 592
|
Re: RIMAC "Nok-In-Out" 21
Sponsored Links (Register now to hide all advertisements)
|
12-03-2023, 08:27 PM | #7 |
Senior Member
Join Date: Mar 2012
Location: Addison,ll.
Posts: 454
|
Re: RIMAC "Nok-In-Out" 21
My Avatar photo has that tool pictured. It was made by Rinck-McKilwaine of New York. You can usually find them hunting on EBay for Rimac tool or nail puller.
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|