The Ford Barn

Egov · 07-24-2014, 11:45 PM

Hey everyone! Just got my 1930 aa running and noticed a little head gasket leak. Figured I'd pull it and have it milled a little for higher compression. My machinest told me to get all the specs and measurements for the head(he's done big flatheads but never a model a) just to make sure its stock and hasn't been cut before. Does any one know where I can find these specs?
Bert's model a is about 25 minutes from my place but ya know the more information the better!!

Also has any one done the t5 tranny swap into a aa yet and if so what kit did you use and was it pretty basic to do or a pain?

Sorry bout repeating the t5 stuff, new to the model a world at 24 years old lol

07-24-2014, 11:45 PM	#1
Egov Junior Member Join Date: Jul 2014 Location: Aurora, co Posts: 7	head specs Hey everyone! Just got my 1930 aa running and noticed a little head gasket leak. Figured I'd pull it and have it milled a little for higher compression. My machinest told me to get all the specs and measurements for the head(he's done big flatheads but never a model a) just to make sure its stock and hasn't been cut before. Does any one know where I can find these specs? Bert's model a is about 25 minutes from my place but ya know the more information the better!! Also has any one done the t5 tranny swap into a aa yet and if so what kit did you use and was it pretty basic to do or a pain? Sorry bout repeating the t5 stuff, new to the model a world at 24 years old lol