Fender to Fender Bracket Fasteners?

[Neil Wilson]

I am looking for pictures.

The current RGJS page 13-9 states that 1930 - production end fasteners for the fender to fender bracket includes a flat washer. Does anyone know the size of that flat washer? I am guessing it is 1/16x3/4.

[Bill Cilker]

Neil
The flat washer was probably the same one used on the fender to splash shield when they used the 1/4" bolt. 1/4" ID X 3/4 OD.

[Mike V. Florida]

for the rear fenders there are 2 sizes of washers listed; 1/16 x 3/4 and 1/16 x 1 1/2, according to the parts price list.

[Neil Wilson]

Originally Posted by Bill Cilker

Neil
The flat washer was probably the same one used on the fender to splash shield when they used the 1/4" bolt. 1/4" ID X 3/4 OD.

Bill - that was my thinking also. I assume that the flat washer would be under the lock washer? However, the front fender brackets do not look like there is room for a flat washer any larger than the nut/lock. A 3/4" flat washer on would extend a little lower than the bracket.

Maybe it is the rear fender brackets which used flat washers (and not the front)?

I checked the two AA's that likely have original front fenders installed and they only have lock washer (no flat washer).

[Neil Wilson]

Sponsored Links (Register now to hide all advertisements)

Does anyone have a picture showing the fender-to-bracket flat wash installed on a 1930/1931?