The Ford Barn - View Single Post

firetique57 · 12-19-2013, 02:14 AM

I have my rear end assembly sitting on saw horses while I finish the brakes and misc. items that need done. There is no speedo gear housing on the torque tube so I'm not sure what the ring and pinion ratio is. My old rear end had a speedo housing with 9/34 stamped on it. I did a search of the forum and found several explanations on how to check it with the rear end attached to the car. Is there a way to figure it out while I have it out and sitting on the saw horses?

Andy

12-19-2013, 02:14 AM	#1
firetique57 Senior Member Join Date: Jul 2011 Location: Walkertown, NC Posts: 105	One more rear end question I have my rear end assembly sitting on saw horses while I finish the brakes and misc. items that need done. There is no speedo gear housing on the torque tube so I'm not sure what the ring and pinion ratio is. My old rear end had a speedo housing with 9/34 stamped on it. I did a search of the forum and found several explanations on how to check it with the rear end attached to the car. Is there a way to figure it out while I have it out and sitting on the saw horses? Andy