Quote:
Originally Posted by hardtimes
I had a auto engine rebuilder/machinist (Dunlop) measure the bearings and lift at: 1.559 and 5/16".
|
The hole in the block for the cam, should be 1.562-50, from Ford, or 1 and 9/16's, I Bore my cam bearings to .002-50, to ..002-90 clearance, as any thing after .002-90, you can feel up, and down movement, and any thing below .002, you will have a slight drag, so I would say your cam is New, as far as the bearings go, I am not getting what the lift was, and uniformity. thanks Herm.