02-26-2024, 10:17 AM
|
#35
|
Senior Member
Join Date: Jul 2011
Location: Redondo Beach, CA
Posts: 5,852
|
Re: Rotor position at TDC
Quote:
Originally Posted by Bob Bidonde
|
Bob, No the segmented belt is not noisy. They are directional tho so you have to ensure they are installed corectly. I use them on my table saw as well.
I originally installed it because with the thicker Murrey Horn Harmonic Balancer I could not fit the stock type belt between to pulley and the frame.
An added bonus is that they can be shortened so you can bypass your water pump or generator if you lose a bearing while out on the road. Until you can get to a place to repair or change them safely. (I have never had to test this tho).
|
|
|