View Single Post
Old 02-23-2011, 02:58 PM   #2
BRENT in 10-uh-C
Senior Member
 
BRENT in 10-uh-C's Avatar
 
Join Date: May 2010
Location: Eastern Tennessee
Posts: 11,485
Default Re: Model A Ford generator

Disconnect the Cut-out wiring and remove the Cut-out from the Generator. Next remove the fan belt. Using a set of jumper cables connected to a charged battery, connect to the Generator and see if it will spin like a motor. If so, in all liklihood it will charge and therefore consider swapping out and installing a good Cut-out with a diode in it.

.
__________________
.

BRENT in 10-uh-C
.
www.model-a-ford.com
...(...Finally Updated!! )

.
BRENT in 10-uh-C is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)