The Ford Barn - View Single Post

1crosscut · 08-27-2012, 05:34 PM

Fred, You can use the dummies or if you already have the repo connectors that connect to the conduits you can remove the spring loaded connectors leaving a couple of nice holes for the new wires to go through. For the extra ground wire(s) I drilled additional holes for them through the connector insulation. I ran a ground wire from one head light to the other head light and then to ground on the frame from that one. Clear as mud I'm sure.
Dave

08-27-2012, 05:34 PM	#20
1crosscut Senior Member Join Date: Feb 2011 Location: Lincoln, Nebraska Posts: 1,934	Re: Headlamp socket question Fred, You can use the dummies or if you already have the repo connectors that connect to the conduits you can remove the spring loaded connectors leaving a couple of nice holes for the new wires to go through. For the extra ground wire(s) I drilled additional holes for them through the connector insulation. I ran a ground wire from one head light to the other head light and then to ground on the frame from that one. Clear as mud I'm sure. Dave Last edited by 1crosscut; 08-27-2012 at 09:57 PM.