[roll of the dices]

Originally Posted by Brentwood Bob

Planojc has the practical answer. I would use poster board, or even Masonite after initial mounting the frame to verify test fit on the car. Use a clean, flat surface as your work area.
The diagrams would be used to verify the template you make. There is a reference to the treatment of the edges. They maybe slightly rounded. I did a long series of youtubes on installing windshield glass in the closed bodies frames that may help with general knowledge.

https://m.youtube.com/watch?v=5h8g7mXy2Rw

The glass holders I made up really help.

Here is another reference:

http://www.ocmafc.com/techarticles/T...%20Install.pdf

Thank you Bob. I watched the vides and it gave me some really good info and tips.