Forum: Model A (1928-31)
07-15-2015, 08:51 PM
|
Replies: 4
Views: 2,029
Brake rods and anti-rattle springs
While adjusting my rear brakes on a 31 Coupe I purchased almost intact after a frame off restoration, I noticed the anti-rattle springs were placed behind the welded knee on the rod. I have had...
|
Forum: Model A (1928-31)
05-25-2015, 09:43 AM
|
Replies: 2
Views: 1,255
|
Forum: Model A (1928-31)
05-24-2015, 10:24 PM
|
Replies: 6
Views: 2,521
|
Forum: Model A (1928-31)
05-24-2015, 10:23 PM
|
Replies: 2
Views: 1,255
Starter Bendix
What are the differences between the Model T and Model A starter bendix. I have a B model engine with a 12 volt starter. It got jammed and I had to remove the starter bolts to get the gear to...
|
Forum: Model A (1928-31)
09-20-2014, 11:20 AM
|
Replies: 14
Views: 2,423
Re: Start relay puzzle
Problem solved!!
Thanks to all who provided input. I disassembled the one I removed and confirmed that the coil was not grounded to the base. I had continuity from the S terminal to the I...
|
Forum: Model A (1928-31)
09-19-2014, 08:32 PM
|
Replies: 14
Views: 2,423
Re: Start relay puzzle
Wow! I thought it was a simple electro-magnet that pulled a bridge across the two large terminals when powered. I purchased the relay only because it is a 12 volt 4 post relay with a curved base...
|
Forum: Model A (1928-31)
09-19-2014, 05:27 PM
|
Replies: 14
Views: 2,423
Re: Start relay puzzle
This is what I have except I have a stand alone start push button on the floorboard instead of routing through the ignition switch.
|
Forum: Model A (1928-31)
09-19-2014, 04:39 PM
|
Replies: 14
Views: 2,423
Re: Start relay puzzle
Great diagram Mike!
I thought this relay was grounded through the mounting base and the I post was not used. This relay has 4 posts (2 large, 2 small) Small ones are marked S and I. Isn't the I...
|
Forum: Model A (1928-31)
09-19-2014, 03:49 PM
|
Replies: 14
Views: 2,423
Start relay puzzle
Have good circuits from battery to car and ground. Close the ground disconnect switch and lights, horn etc work. Push start button nothing happens. Checked start button normal open. pushed have...
|
Forum: Model A (1928-31)
09-08-2014, 09:04 PM
|
Replies: 8
Views: 2,102
Ahoo but no Gaa
Installed my 6 volt horn with the horn resistor from Bratton's to work with my 12 volt system and pushed the horn button. After adjusting the screw on the back of the horn until just getting a good...
|
Forum: Model A (1928-31)
09-03-2014, 09:33 PM
|
Replies: 7
Views: 1,532
Re: B-7 generator
I do not know since the motor has not been run yet. Is this a rebuilt Model A generator or maybe a 12 volt 1932 or later generator? Anybody know?
|
Forum: Model A (1928-31)
09-03-2014, 05:54 PM
|
Replies: 7
Views: 1,532
B-7 generator
My 31 coupe has a model B engine that the previous owner partially converted to 12 volt. The generator looks like a Model A generator but has two wires comming from the hole where the original had a...
|
Forum: Model A (1928-31)
08-06-2014, 09:15 PM
|
Replies: 2
Views: 1,053
Electrical Power ON!
I just applied battery power to my 31 Coupe:). I have been wiring it since purchasing this spring. Have turn signals and headlights but the ammeter is wired backward:mad:. I have 12 volt halogen...
|
Forum: Model A (1928-31)
07-23-2014, 09:10 PM
|
Replies: 8
Views: 1,604
Re: 31 Coupe wire routing query
Sorry, my mistake. The dome light will be connected to the terminal box. I was confused because I decided to make the cowl lights dedicated turn signal lights and so will be connected to the turn...
|
Forum: Model A (1928-31)
07-23-2014, 09:05 PM
|
Replies: 8
Views: 1,604
Re: 31 Coupe wire routing query
1ea 14 gage wire from my starter batt terminal to the ignition switch dedicated with a 20 amp fuse for the electronic ignition.
2 ea 18 gage wires from the add on rear turn signal lights going to...
|
Forum: Model A (1928-31)
07-23-2014, 04:27 PM
|
Replies: 8
Views: 1,604
Re: 31 Coupe wire routing query
I understand the dome light wire runs up the windshield post but where does it pass through from the engine compartment to the interior windshield post? Where is the firewall pass through?
|
Forum: Model A (1928-31)
07-23-2014, 12:09 PM
|
Replies: 8
Views: 1,604
31 Coupe wire routing query
I need to run a couple of wires from the engine compartment to the interior side of the firewall. What is the best way to route the wires? Can I go through the terminal block opening or will that...
|
Forum: Model A (1928-31)
07-18-2014, 10:25 AM
|
Replies: 5
Views: 1,088
|
Forum: Model A (1928-31)
07-17-2014, 10:24 AM
|
Replies: 5
Views: 1,088
Late 31 with B model engine and carb question
The B model carb has the fuel line inlet on the facing fwd on the carb. With the fuel SOV on the firewall, is there any provision for a fuel filter either in the valve, line or carb inlet?
|
Forum: Model A (1928-31)
07-14-2014, 05:01 PM
|
Replies: 2
Views: 1,350
Re: More wiring diagram questions
Thanks, I do see it now. Charging of the battery will flow from generator through the ammeter and back to the battery post on the starter solenoid.
|
Forum: Model A (1928-31)
07-14-2014, 10:57 AM
|
Replies: 2
Views: 1,350
More wiring diagram questions
I have a 31 coupe that came with a partially modified 12 volt system and an FS electronic ignition. It had no wiring harness installed. I have researched all the threads regarding wiring and have...
|
Forum: Model A (1928-31)
07-05-2014, 08:19 PM
|
Replies: 7
Views: 7,334
|
Forum: Model A (1928-31)
07-05-2014, 04:32 PM
|
Replies: 7
Views: 7,334
31 Coupe windshield swing arm installation issue
I just installed my windshield in the coupe and when I attached the swing arms, the windshield would not close all the way. The angle of the swing arm between the windshield attach bracket and the...
|
Forum: Model A (1928-31)
07-04-2014, 10:41 AM
|
Replies: 6
Views: 2,333
Re: Amber cowl light bulbs
Just ordered the 97A bulb but then found another in the website, a 67NA for less than half the cost. The difference is the 97A is a painted glass and the 67NA is a colored glass. What is better...
|
Forum: Model A (1928-31)
07-03-2014, 11:28 PM
|
Replies: 6
Views: 2,333
Amber cowl light bulbs
I would like my cowl lights to be used as only turn signal lights. I do not want to change the lens to an amber lens so as to keep a more stock look however I cannot find any amber 12 volt 6-10 watt...
|