Forum: Model A (1928-31)
04-11-2024, 07:08 PM
|
Replies: 6
Views: 644
Re: Tie Rod Replacement
Hello, mine were probably replaced a long time ago, marked at Thompson Products on them I think that’s TRW today.
|
Forum: Model A (1928-31)
04-10-2024, 05:18 PM
|
Replies: 25
Views: 1,692
Re: Car will not start
Check timing with the plug provided to make sure timing gear is good, then drain gas from tank , and if possible put in a few gallons of non ethanol if available in your area. Ethanol fuel has a bad...
|
Forum: Model A (1928-31)
04-04-2024, 05:30 PM
|
Replies: 21
Views: 1,880
Re: How tight should the...
Hello, as per last 3 posts , that was my reasoning also for using the plastic inserts, easier than replacement of steering arms ,again.
|
Forum: Model A (1928-31)
03-29-2024, 11:30 AM
|
Replies: 21
Views: 1,770
|
Forum: Model A (1928-31)
03-29-2024, 11:18 AM
|
Replies: 16
Views: 893
Re: Serial Number and Year of production
Hello, I have seen that on Pennsylvania titled cars of that era , a 1940 Pontiac that was sold in December of 1939 , titled as 1939 .This was a two owner car with the original title.Also with Model A...
|
Forum: Model A (1928-31)
03-26-2024, 07:34 PM
|
Replies: 19
Views: 1,776
Re: Timing gears
Always a demand for a cheaper product.Was a post on here about non fitting repro parts and cost seem to come up quite often.
|
Forum: Model A (1928-31)
03-13-2024, 10:53 AM
|
Replies: 11
Views: 932
Re: Engine paint
Hello, I have also heard what post 2 and 4 said In thier posts ,can’t imagine Ford wasting much in the factory.Green must have been a popular color for engines then .
|
Forum: Model A (1928-31)
03-09-2024, 09:51 PM
|
Replies: 16
Views: 901
Re: Electric Fuel Shut off
Hello, I have one on my 31 , installed by previous owner, seems to work ok , does have separate shut off switch, also have a master switch on battery. Better than having to raze hood to use factory...
|
Forum: Model A (1928-31)
03-08-2024, 12:47 PM
|
Replies: 9
Views: 783
Re: Wheel Well Patch Panels
Hello, I can say for sure the repro panels have short comings at least on a 31 roadster .As suggested just repair the rusted areas and use weld . The car I am working on was hit on passenger side and...
|
Forum: Model A (1928-31)
03-07-2024, 02:52 PM
|
Replies: 17
Views: 1,174
Re: Why a fabric roof?
Hello, I also read about the limitations of steel press size in that era , the larger press were used for front fenders in particular. The Ist Fords common built with all steel roofs were the 1937...
|
Forum: Model A (1928-31)
03-06-2024, 08:56 PM
|
Replies: 41
Views: 3,639
|
Forum: Model A (1928-31)
03-06-2024, 03:29 PM
|
Replies: 5
Views: 503
|
Forum: Model A (1928-31)
03-06-2024, 03:00 PM
|
Replies: 37
Views: 4,403
Re: New Radiator Opinions
Hello, agree that it is hard to find a radiator repair shop anymore, had mine repaired after checking with four other shops, only one could actually clean and repair it, they went out of business...
|
Forum: Model A (1928-31)
03-05-2024, 10:23 PM
|
Replies: 6
Views: 452
|
Forum: Model A (1928-31)
03-05-2024, 09:49 PM
|
Replies: 23
Views: 1,775
Re: Light Wire Harness Bucket Seized/Issues
Hello, had some trouble with mine and found the small c clip the attached at the bottom of the rod was missing, it keeps the spring under tension without it the the forked selector would bind in the...
|
Forum: Model A (1928-31)
03-05-2024, 09:28 PM
|
Replies: 6
Views: 452
Re: Front seatback riser question
Hello again, the 31 has a angle bracket that mounts to body sub frame and attachs to the quarter panel, which is is probably different than the 28 29 . The bracket reinforces the quarter panel quite...
|
Forum: Model A (1928-31)
03-05-2024, 06:16 PM
|
Replies: 6
Views: 452
|
Forum: Model A (1928-31)
03-04-2024, 06:14 PM
|
Replies: 4
Views: 523
Re: '29 Standard Roaster Headlight question
Hello, one possibility could be car has wrong year on title, depending on the state , sometimes cars were titled the year they were first sold, I seen a 1940 Pontiac titled as a 1939 , also a 1929...
|
Forum: Model A (1928-31)
02-26-2024, 09:57 PM
|
Replies: 16
Views: 1,219
Re: Ford car Ford gas
I remember those Ford gum ball machines, was one in front of the Tom Mccans shoe store.
|
Forum: Model A (1928-31)
02-25-2024, 10:36 AM
|
Replies: 4
Views: 542
Re: Ford wire wheel
Hello, 1932 Fords had 18 inch rims, the only year to do so as standard equipment, 1933 34 also known as Model 40 have 17 inch rims . As mentioned a picture would help.
|
Forum: Model A (1928-31)
02-22-2024, 05:56 PM
|
Replies: 10
Views: 1,763
|
Forum: Model A (1928-31)
02-18-2024, 06:39 PM
|
Replies: 5
Views: 468
Re: 31 Std. Roadster Wiper Motor
Hello again, that flap does cut down on wind slightly when fastened to windshield, forgot to snap it down , and wondered why it was noiser than usual.
|
Forum: Model A (1928-31)
02-18-2024, 11:16 AM
|
Replies: 5
Views: 468
Re: 31 Std. Roadster Wiper Motor
Hello, this is a Deluxe top but picture shows the flap you mentioned, flap would be similar but in black cross grain , and of course the top bow is different.
|
Forum: Model A (1928-31)
02-18-2024, 10:51 AM
|
Replies: 26
Views: 2,007
Re: Backfire
Hello, known electric problems are , condenser, ignition switch, both repro and original, if not rebuilt, the wire inside the cable will short out , repro points that don’t line up and block wears...
|
Forum: Model A (1928-31)
02-18-2024, 10:39 AM
|
Replies: 58
Views: 3,301
Re: Favorite "A" Body Style
Hello, can I pick two? 40 B Deluxe Roadster, have a 31 , and 1931 slant windshield sedan. If I should get another Model A that’s what it would be.
|