Forum: Model A (1928-31)
12-26-2023, 10:31 AM
|
Replies: 46
Views: 4,633
Re: Fuel Filter issue
Big Hammer, thanks for replying. I will try to get it to work. I can only get it to dribble the gas slowly, certainly not a flow.
|
Forum: Model A (1928-31)
12-24-2023, 08:42 PM
|
Replies: 46
Views: 4,633
Re: Fuel Filter issue
Can you use an in-tank fuel filter inserted in the shut-off value of a late 31 Model A? I know that they are used in the earlier Model A's when the shut-off valve is inside the car.
|
Forum: Model A (1928-31)
05-26-2023, 03:04 PM
|
Replies: 7
Views: 918
|
Forum: Model A (1928-31)
05-23-2023, 04:47 PM
|
Replies: 7
Views: 918
Re: Clutch disk - 4 speed transmission
I am off too Auto Zone to place an order. I assume you have the converted F 150 Transmission as I do. Easy to drive with it but a little tough on some hills.
Thanks for your response.
Bob
|
Forum: Model A (1928-31)
05-23-2023, 04:45 PM
|
Replies: 7
Views: 918
|
Forum: Model A (1928-31)
05-22-2023, 09:35 PM
|
Replies: 7
Views: 918
Clutch disk - 4 speed transmission
I have a 4 speed transmission that I believe started it life in a ford 150 truck. It was adapted to fit a Model A. I am searching for a part number for the clutch disc. The hub of the Model A clutch...
|
Forum: Model A (1928-31)
10-23-2022, 07:15 PM
|
Replies: 17
Views: 4,964
Re: Panel Delivery at the Ford Museum?
Jerry,
Beautiful truck. I am helping to sell a friend's 1931 Panel truck. His
looks like the one you have in the museum. Is there a difference between a Model A Panel truck and a Panel...
|
Forum: Model A (1928-31)
10-27-2021, 02:35 PM
|
Replies: 10
Views: 1,355
|
Forum: Model A (1928-31)
10-12-2021, 07:23 PM
|
Replies: 10
Views: 1,355
Testing Starter
How many amps should a 12V starter draw on a bench test? Same question for a 6V starter. How many amps should the 12V and 6V starters draw when installed? Thank you.
Bob
|
Forum: Model A (1928-31)
07-21-2020, 06:02 PM
|
Replies: 1
Views: 1,069
Front Brake Shaft -
How do you determine if the cup in the front brake shaft is too worn to work properly? Is there a certain depth to the cup in the shaft? How far in into the cup should the operating pin fit? Thanks....
|
Forum: Model A (1928-31)
02-02-2019, 02:48 AM
|
Replies: 1
Views: 1,163
More leg room in Cabriolet
I'm looking for ideas on gaining more leg room in my 1930 Cabriolet with non-adjustable seat. If any of you have made such a modification, I would like to know what you did. I was thinking of...
|
Forum: Model A (1928-31)
12-27-2018, 12:06 PM
|
Replies: 2
Views: 1,236
Re: Slant Window window regulator springs
Thanks JW. We will make a change today as I have a extra correct smaller spring. I tried to find a large one and it took a while. I know that they are difficult to find and I will so the same as...
|
Forum: Model A (1928-31)
12-27-2018, 01:18 AM
|
Replies: 2
Views: 1,236
Slant Window window regulator springs
I was having difficulty primarily raising and to a lesser degree lowering the drivers window on my slant window sedan. The channels seem OK as I had replaced them some years earlier. After removing...
|
Forum: Model A (1928-31)
10-29-2018, 06:09 PM
|
Replies: 6
Views: 1,435
Window regulator spring - Slant Window
Help!! I'm looking for the larger of the two springs for the front driver's door window regulator on my slant window Model A. Told by Brattons they are no longer made. Tried Bill's in Pennsylvania...
|
Forum: Model A (1928-31)
08-18-2018, 12:29 AM
|
Replies: 17
Views: 2,674
Re: Cable shifter
I have a cable shifter on my '31 slant window. I added the overdrive to my F150 4 speed transmission because of the gap between second and third. I would go up a good hill in second gear at max 25...
|
Forum: Model-A
10-09-2017, 11:47 PM
|
Replies: 0
Views: 688
1930 Deluxe Fordor Sedan
1930 Deluxe Fordor Sedan. Total restoration in 2011 by professional restorer Charles A. McKeown. Seventy-eight thousand five hundred original miles and driven 21 miles since restoration. Health...
|
Forum: Model A (1928-31)
09-17-2017, 12:00 AM
|
Replies: 16
Views: 2,423
Re: International Model A Day
The San Gabriel Valley Model A Restorers Club, the Santa Anita A's and the Diamond Tread Chapter of MAFCA celebrated the day with a poker run followed by a freshly prepared taco lunch with Klondike...
|
Forum: Model A (1928-31)
03-04-2017, 09:14 PM
|
Replies: 9
Views: 2,342
Unfamiliar bell housing
Found this mixed in with my Model A parts and don't know what car it fits? Appreciate your help. Thanks.
Bob
|
Forum: Model A (1928-31)
02-04-2017, 12:05 AM
|
Replies: 10
Views: 2,140
|
Forum: Model A (1928-31)
01-30-2017, 03:20 PM
|
Replies: 10
Views: 2,140
Water pump rebuilder
I need to have my water pump rebuilt. Can you recommend someone?
Thank you.
Bob
|
Forum: Model A (1928-31)
08-13-2016, 02:09 PM
|
Replies: 3
Views: 1,610
|
Forum: Model A (1928-31)
08-12-2016, 10:33 PM
|
Replies: 3
Views: 1,610
Adjusting ford 150 steering box
The original steering box in my 1931 sedan had been replaced with the steering box from the ford 150 when I purchased the car. It has more play in the steering wheel than the tight steering in my...
|
Forum: Model A (1928-31)
05-12-2016, 07:26 PM
|
Replies: 1
Views: 1,465
Youth and Model A Restoration
The Model A Restoration Award program provides financial assistance to youth between the ages of 12 and less than 22 who are restoring their Model As. This assistance is made biennially and the 2016...
|
Forum: Model A (1928-31)
02-10-2016, 11:11 PM
|
Replies: 13
Views: 3,428
Re: 6 Volt alternator conundrum
Today I discovered that the cable between the battery and the starter was not completely tight at the starter. After tightening it, my alternator started working correctly on my friends car.
The...
|
Forum: Model A (1928-31)
02-09-2016, 11:29 PM
|
Replies: 13
Views: 3,428
Re: 6 Volt alternator conundrum
Thank you Tom. I may have an answer to why the alternator that I have had at the shop isn't working properly.On the Nu-Rex Site , there is an alternator short circuit test. It indicates a short...
|