Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Page 1 of 20 1 234511 Last »
Showing results 1 to 25 of 500
Search took 0.11 seconds. Search: Posts Made By: Kube
Forum: Early V8 (1932-53) Yesterday, 12:08 PM
Replies: 5
Views: 305
Posted By Kube
Re: What is this ?

FYI, The compression fitting is not only unsafe within the brake line, it's illegal.
Forum: Early V8 (1932-53) Yesterday, 10:09 AM
Replies: 13
Views: 549
Posted By Kube
Re: Rusted 1940 cab

Do you want photos of the inside of the floor?
Forum: Early V8 (1932-53) Yesterday, 09:14 AM
Replies: 10
Views: 297
Posted By Kube
Re: Tail light connectore

Yep. They will work but you will need to grind down the diameter a bit. As is, they will not fit the connector.
Forum: Early V8 (1932-53) Yesterday, 07:26 AM
Replies: 7
Views: 296
Posted By Kube
Re: Tips or a product that will clean radiator hoses?

Lacquer thinner & scrubby pad.
Forum: Early V8 (1932-53) 05-23-2024, 04:16 PM
Replies: 10
Views: 321
Posted By Kube
Re: Oil filter emergency bypass

As goofy as it may sound, I have reused the old gasket with a 100% success rate.
Forum: Early V8 (1932-53) 05-22-2024, 04:30 PM
Replies: 11
Views: 552
Posted By Kube
Re: Banjo rear end hub, axle bearings and seals

The reproductions have a sorted history of poor quality. The cages were not (are not?) hardened properly and rather quickly, the cage would fail and the bearings were free to go where they wanted....
Forum: Early V8 (1932-53) 05-22-2024, 08:47 AM
Replies: 4
Views: 293
Posted By Kube
Re: Clutch pedal return spring '40 passenger

Here are two photographs that should help you. Note the hole atop the brace for one end of the spring to attach to.
I believe if you zoom in on the other photograph, you'll be able to see how the...
Forum: Early V8 (1932-53) 05-21-2024, 07:03 PM
Replies: 13
Views: 549
Posted By Kube
Re: Rusted 1940 cab

Found one more. I think that's all I have of what you wanted. Hope it helps...
Forum: Early V8 (1932-53) 05-21-2024, 04:50 PM
Replies: 13
Views: 549
Posted By Kube
Re: Rusted 1940 cab

Do these help?
Forum: Early V8 (1932-53) 05-21-2024, 02:31 PM
Replies: 11
Views: 552
Posted By Kube
Re: Banjo rear end hub, axle bearings and seals

Do NOT buy reproduction caged bearings.
Forum: Early V8 (1932-53) 05-20-2024, 08:48 PM
Replies: 14
Views: 738
Posted By Kube
Re: 1932/36 Condenser replacement.

Yes sir!
Forum: Early V8 (1932-53) 05-20-2024, 07:16 PM
Replies: 14
Views: 738
Posted By Kube
Re: 1932/36 Condenser replacement.

For my cars and those clients that allow me to do what I prefer, I too use the 32's.
I think the last time I bought them; they were about $28. A bargain considering the confidence a guy gets with...
Forum: Early V8 (1932-53) 05-20-2024, 02:15 PM
Replies: 7
Views: 602
Posted By Kube
Re: sagging drivers door -1936 ford tudorsedan

I tend to align doors without the dovetail in place. I don't want to rely on the dovetail moving the door into position.
Forum: Early V8 (1932-53) 05-18-2024, 01:39 PM
Replies: 14
Views: 738
Posted By Kube
Re: 1932/36 Condenser replacement.

I use a Hunt's Magneto condenser. I have used both the 28mfd and 32mfd units. GREAT reliability. With the coil you are using, solder the original "bracket end" on to the condenser and shove the...
Forum: Early V8 (1932-53) 05-18-2024, 01:34 PM
Replies: 12
Views: 508
Posted By Kube
Re: Crab distributor vacuum line

Guys, guys, guys...
That's an incorrect manifold for the 59A. The correct manifold has an integral threaded hole just below the carburetor base. There is a special fitting that allows vacuum to be...
Forum: Early V8 (1932-53) 05-18-2024, 07:33 AM
Replies: 19
Views: 780
Posted By Kube
Re: '46 Coupe 59AB Starter

I would also use it.
Forum: Early V8 (1932-53) 05-17-2024, 09:43 AM
Replies: 7
Views: 282
Posted By Kube
Re: 40 Sedan Deluxe Speaker install - No studs?

That sounds like a good idea Jim.
Forum: Early V8 (1932-53) 05-17-2024, 07:38 AM
Replies: 7
Views: 282
Posted By Kube
Re: 40 Sedan Deluxe Speaker install - No studs?

The speaker was originally integral of the radio.
As you are attempting to modify your car, well, it's up to you to figure out how to do so.
Forum: Model A (1928-31) 05-16-2024, 06:01 PM
Replies: 12
Views: 713
Posted By Kube
Re: my project and my thanks...

The spare tire I placed in there. I doubt that was how it was back in the day.
Forum: Model A (1928-31) 05-16-2024, 07:07 AM
Replies: 19
Views: 1,012
Posted By Kube
Re: Lacquer Paint fix?

Just in case some folks don't believe you, I'd like to attest to the truth in your advice.
I used to buy that giant can of black shoe polish marketed as vinyl top dressing. Wax a black or marron...
Forum: Early V8 (1932-53) 05-15-2024, 06:01 PM
Replies: 11
Views: 1,514
Posted By Kube
Re: Passenger Door Latch Mechanism

Not here
Forum: Early V8 (1932-53) 05-15-2024, 03:05 PM
Replies: 2
Views: 169
Posted By Kube
Re: 39 delux center hood nose trim

nope
Forum: Early V8 (1932-53) 05-14-2024, 07:15 PM
Replies: 16
Views: 753
Posted By Kube
Re: Nice forty Ford

A valid point indeed!
Forum: Early V8 (1932-53) 05-14-2024, 05:37 PM
Replies: 16
Views: 753
Posted By Kube
Re: Nice forty Ford

I've attached a photo of a properly restored heavy duty filter.
This type was described as to be used in extreme dusty conditions. I doubt many found their way on to a car. Still, they were...
Forum: Early V8 (1932-53) 05-14-2024, 05:35 PM
Replies: 16
Views: 753
Posted By Kube
Re: Nice forty Ford

No one can tell us with certainty what happened back in the various assembly plants.
That being said, it's possible the covers did get painted body color at some plant, at some moment in time....
Showing results 1 to 25 of 500
Page 1 of 20 1 234511 Last »

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 11:57 AM.