Need photos of 29 coupe body / top wood - mine are gone Before I started taking apart the insides of our 29 standard coupe I took lots of digital photos so I could get it back together.
I've had a mishap with the photos and they are all gone. I've been doing searches on the site looking for any photos that would help me put things back together but so far I've not been very successful. Does anyone have any photos of the inside wood, mostly around the side/rear window of a 29 coupe? I've only been able to find photos for '30/31 and they have been only somewhat helpful. If anyone could share photos of the wood for their 29 could I would greatly appreciate it. |
Re: Need photos of 29 coupe body / top wood - mine are gone http://img.photobucket.com/albums/v4...A/DSCF3677.jpg
http://img.photobucket.com/albums/v4...A/DSCF3676.jpg http://img.photobucket.com/albums/v4...A/DSCF3675.jpg http://img.photobucket.com/albums/v4...A/DSCF3674.jpg http://img.photobucket.com/albums/v4...A/DSCF3673.jpg http://img.photobucket.com/albums/v4...A/DSCF3672.jpg http://img.photobucket.com/albums/v4...A/DSCF3671.jpg Hope those help.... They are not the best and from a few years ago. Edit: Just found a couple more http://img.photobucket.com/albums/v4...A/IMAG2287.jpg http://img.photobucket.com/albums/v4...A/IMAG2288.jpg http://img.photobucket.com/albums/v4...A/IMAG2289.jpg http://img.photobucket.com/albums/v4...A/IMAG2290.jpg |
Re: Need photos of 29 coupe body / top wood - mine are gone Thebanjoman,
I don't know if you are installing new wood in your car, but I would recommend it. If you had original wood in it and reinstall it, if there are any rotten places (soft areas), usually unseen, you could have a tough time installing upholstery, rain gutter, etc if the nail wont hold. I recently installed a complete new body and top wood kit from Classic Wood in my 28 special coupe (quite similar to a standard 28/29 coupe) and the wood pieces are fairly easy to identify where they fit. If you need help, I or other Fordbarners would surly help. Rusty Nelson |
Re: Need photos of 29 coupe body / top wood - mine are gone Quote:
I purchased new new wood to go in. Almost every piece I had was soft or came apart when I took it apart. Most of the hardware was rusted, pitted, falling apart. I was able to clean up the brackets and my pictures were going to be i big help, but a disk crash and they are gone. I'd like to have them back but sending it off for data recovery is cost prohibitive. I found it disheartening that I can get hardware kits for 30/31 but not for 28/29, at least from the places I looked, MACs, Snyders, Brattons, If a hardware kit exists for the 28/29 for the body and top wood I sure wish I could find it. |
Re: Need photos of 29 coupe body / top wood - mine are gone When I installed my wood kit, I used stainless steel machine screws and wood screws. I saved what was left of the old wood with the screws attached the best I could. I found that most machine screws were #10 flathead and roundhead. Almost all the wood screws are flathead. The nice thing about SS is you can cut them off and they would rust and possibly get stains on the roof liner.
Rusty Nelson |
Re: Need photos of 29 coupe body / top wood - mine are gone Quote:
|
Re: Need photos of 29 coupe body / top wood - mine are gone WWW.FORDWOOD.COM HAD SOME PRETTY GOOD DRAWINGS. Bill W.
|
Re: Need photos of 29 coupe body / top wood - mine are gone Quote:
|
Re: Need photos of 29 coupe body / top wood - mine are gone Quote:
|
Re: Need photos of 29 coupe body / top wood - mine are gone Quote:
|
All times are GMT -5. The time now is 03:53 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.