oil pump modification? 1 Attachment(s)
I read the thread on the Burtz motor oil pump modifications and am wondering if I need to open the slots on the new oil pump just purchased before I install it in a stock engine. His modifications are for his block and oiling system. Pic enclosed of the slots in my pump. I have access to any machine work needed.Attachment 520463
|
Re: oil pump modification? Yes, you will need to open the outlets up a bit, and also block off the slots at the top of the tube to allow the oil to exit to an external filter, if you plan on using one.
Fank |
Re: oil pump modification? The oiling system on the Burtz is totally different from a stock Model A.
|
Re: oil pump modification? 1 Attachment(s)
Opened both of the slots with a 1/4 end mill. installing the pan tomorrow.
|
Re: oil pump modification? I always open them up to 5/16 or 3/8 even on a stock motor.
|
Re: oil pump modification? Next step is to reduce the diameter of the pump shaft to give additional clearance for oil flow.
|
Re: oil pump modification? Quote:
|
All times are GMT -5. The time now is 08:57 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.